Private:Ahmed Reading Summaries

Will summarize the readings here..

Peer-to-Peer and SVC

Peer-Driven Video Streaming: Multiple Descriptions versus Layering
Layered Coding vs. Multiple Descriptions for Video Streaming over Multiple Paths
Evaluation of the H.264 Scalable Video Coding in Error Prone IP Networks
Overview of the Scalable Video Coding Extension of the H.264/AVC Standard
Enabling Adaptive Video Streaming in P2P Systems

Long Term Evolution (LTE)

Mobile Video Transmission Using Scalable Video Coding
LTE - An Introduction
Optimal Transmission Scheduling for Scalable Wireless Video Broadcast with Rateless Erasure Correction Code
Dynamic Session Control for Scalable Video Coding over IMS
Scheduling and Resource Allocation for SVC Streaming over OFDM Downlink Systems
Mobile Broadband: Including WiMAX and LTE
- Chapter-11: Long Term Evolution of 3GPP
3G Evolution HSPA and LTE for Mobile Broadband
- Chapter-11: MBMS: Multimedia Broadcast Multicast Service
The UMTS Long Term Evolution: From Theory to Practice
- Chapter-2: Network Architecture
- Chapter-14: Broadcast Operation

Acronyms

3GPP 3rd Generation Partnership Project
BM-SC Broadcast Multicast Service Centre
CN Core Network
CP Cyclic Prefix
EPC Evolved Packet Core
EPS Evolved Packet System
ICI InterCell Interference
LTE Long Term Evolution
MANE Media-Aware Network Element
MBMS Multimedia Broadcast Multicast Service
MIMO Multiple Input Multiple Output
OFDM Orthogonal Frequency Division Multiplexing
OFDMA Orthogonal Frequency Division Multiple Access
SAE System Architecture Evolution
SC-FDMA Single Carrier Frequency Division Multiple Access
TTI Transmission Time Interval
UE User Equipment
UTRAN UMTS Terrestrial Radio Access Network

Long Term Evolution of 3GPP

LTE PHY Layer

Based on OFDMA with cyclic prefix in downlink, and on SC-FDMA with a cyclic prefix in the uplink
Three duplexing modes are supported: full duplex FDD, half duplex FDD, and TDD
Two frame structure types:
- Type-1 shared by both full- and half-duplex FDD
- Type-2 applicable to TDD
Type-1 radio frame has a length of 10 ms and contains 20 slots (slot duration is 0.5 ms)
Two adjacent slots constitute a subframe of length 1 ms
Supported modulation schemes are: QPSK, 16QAM, 64QAM
Broadcast channel only uses QPSK
Maximum information block size = 6144 bits
CRC-24 used for error detection

Type-1 Frame

Type-2 Frame

OFDMA Downlink

Scheduler in eNB (base station) allocates resource blocks (which are the smallest elements of resource allocation) to users for predetermined amount of time
Slots consist of either 6 (for long cyclic prefix) or 7 (for short cyclic prefix) OFDM symbols
Longer cyclic prefixes are desired to address longer fading
Number of available subcarriers changes depending on transmission bandwidth (but subcarrier spacing is fixed)

Download Resource Block

Slot Structure

Evolved Multicast Broadcast Multimedia Services (eMBMS)

Is a multimedia service performed either with a single-cell broadcast or multicell mode (aka MBMS Single Frequency Network (MBSFN))
In an MBSFN area, all eNBs are synchronized to perform sumulcast transmission from multiple cells (each cell transmitting identical waveform)
There are three types of cells within an MBSFN area: transmitting/receiving, transmitting only, and reserved
If user is close to a base station, delay of arrival between two cells could be quite large, so the subcarrier spacing is reduced to 7.5 KHz and longer CP is used

LTE MAC Layer

eNB scheduler controls the time/frequency resources for a given time for uplink and downlink
Scheduler dynamically allocates resources to UEs at each Transmission Time Interval (TTI)
Depending on channel conditions, scheduler selects best multiplexing for UE
Downlink LTE considers the following schemes as a scheduler algorithm:
- Frequency Selective Scheduling (FSS)
- Frequency Diverse Scheduling (FDS)
- Proportional Fair Scheduling (PFS)
Link adaptation is performed through adaptive modulation and coding

LTE Radio Interface Architecture

Data to be transmitted in the downlink enters the processing chain in the form of IP packets on one of the SAE bearers
IP packets are passed through multiple protocol entities:
- Packet Data Convergence Protocol (PDCP) performs IP header compression, to reduce the number of bits to transmit over the radio interface, based on Robust Header Compression (ROHC) in addition to ciphering and integrity protection of the transmitted data
- Radio Link Control (RLC) is responsible for segmentation/concatenation, retransmission handling, and in-sequence delivery to higher layers
  - offers services to the PDCP in the form of radio bearers
- Medium Access Control (MAC) handles hybrid-ARQ retransmissions and uplink and downlink scheduling at the eNodeB
  - offers services to the RLC in the form of logical channels
- Physical Layer (PHY) handles coding/decoding, modulation/demodulation, multi-antenna mapping, and other typical physical layer functions
  - offers services to the MAC layer in the form of transport channels

RLC

Depending on the scheduler decision, a certain amount of data is selected for transmission from the RLC SDU buffer and the SDUs are segmented/concatenated to create the RLC PDU. Thus, for LTE the RLC PDU size varies dynamically
In each RLC PDU, a header is included, containing, among other things, a sequence number used for in-sequence delivery and by the retransmission mechanism
A retransmission protocol operates between the RLC entities in the receiver and transmitter. By monitoring the sequence numbers of the incoming PDUs, the receiving RLC can identify missing PDUs
Although the RLC is capable of handling transmission errors due to noise, unpredictable channel variations, etc., error-free delivery is in most cases handled by the MAC-based hybrid-ARQ protocol

MAC

A logical channel is defined by the type of information it carries and is generally classified as:
- a control channel, used for transmission of control and configuration information necessary for operating an LTE system
- a traffic channel, used for the user data
A transport channel is defined by how and with what characteristics the information is transmitted over the radio interface
Data on a transport channel is organized into transport blocks. In each Transmission Time Interval (TTI), at most one transport block of a certain size is transmitted over the radio interface to/from a mobile terminal in absence of spatial multiplexing
Associated with each transport block is a Transport Format (TF), specifying how the transport block is to be transmitted over the radio interface (it includes information such as transport-block size, the modulation scheme, and the antenna mapping)
By varying the transport format, the MAC layer can realize different data rates. Rate control is therefore also known as transport-format selection
In LTE, radio access is shared-channel transmission, that is time–frequency resources are dynamically shared between users. The scheduler is part of the MAC layer and controls the assignment of uplink and downlink resources
The downlink scheduler is responsible for dynamically controlling the terminal(s) to transmit to and, for each of these terminals, the set of resource blocks upon which the terminal’s DL-SCH should be transmitted
The scheduling strategy is implementation specific and not specified by 3GPP
- the overall goal of most schedulers is to take advantage of the channel variations between mobile terminals and preferably schedule transmissions to a mobile terminal on resources with advantageous channel condition
The mobile terminal transmits channel-status reports reflecting the instantaneous channel quality in the time and frequency domains, in addition to information necessary to determine the appropriate antenna processing in case of spatial multiplexing
Interference coordination, which tries to control the inter-cell interference on a slow basis, is also part of the scheduler
Hybrid ARQ is not applicable for all types of traffic (broadcast transmissions typically do not rely on hybrid ARQ). Hence, hybrid ARQ is only supported for the DL-SCH and the UL-SCH
In hybrid ARQ, multiple parallel stop-and-wait processes are used (this can result in data being delivered from the hybrid-ARQ mechanism out-of-sequence, in-sequence delivery is ensured by the RLC layer)

Physical Layer

In the downlink, the DL-SCH is the main channel for data transmission, but the processing for PCH and MCH is similar
A CRC, used for error detection in the receiver, is attached, followed by Turbo coding for error correction
Rate matching is used not only to match the number of coded bits to the amount of resources allocated for the DL-SCH transmission, but also to generate the different redundancy versions as controlled by the hybrid-ARQ protocol
After rate matching, the coded bits are modulated using QPSK, 16QAM, or 64QAM, followed by antenna mapping
The output of the antenna processing is mapped to the physical resources used for the DL-SCH
The resources, as well as the transport-block size and the modulation scheme, are under control of the scheduler (of the MAC layer)
For the broadcast of system information on the BCH, a mobile terminal must be able to receive this information channel as one of the first steps prior to accessing the system. Consequently, the transmission format must be known to the terminals a priori and there is no dynamic control of any of the transmission parameters from the MAC layer in this case

Mobile Video Transmission Using Scalable Video Coding

In current system architectures, the differentiation of data is very coarse (each flow is only differentiated among four classes: conversational, streaming, interactive, and background). Individual packets within each flow are all treated the same.
Investigating per packet QoS would enable general packet marking strategies (such as Differentiated Services). This can be done by either:
- Mapping SVC priority information to Differentiated Services Code Point (DSCP) to introduce per packet QoS
- Making the scheduler media-aware (e.g. by including some MANE-like functinality), and therefore able to use priority information in the SVC NAL unit header
Many live-media distribution protocols are based on RTP, including p-t-m transmission (e.g. DVB-H or MBMS). Provision of different layers, on different multicast addresses for example, allows for applying protection strength on different layers
By providing signalling in the RTP payload header as well as in the SDP session signalling, adaptation (for bitrate or device capability) can be applied in the network by nodes typically known as MANE,
MBMS extends existing 3GPP architecture by introducing:
- MBMS Bearer Service delivers IP multicast datagrams to multiple receivers using minimum radio and network resources and provides an efficient and scalable means to distribute multimedia content to mobile phones
- MBMS User Services
  - streaming services - a continuous data flow of audio and/or video is delivered to the user's handset
  - download services - data for the file is delivered in a scheduled transmission timeslot
The p-t-m MBMS Bearer Service does neither allow control, mode adaptation, nor retransmitting lost radio packets (thus, QoS provided for transport of multimedia applications is in general not sufficiently high to support a significant portion of the users for either download or streaming applications)
Consequently, 3GPP included an application layer FEC based on Raptor codes for MBMS
MBMS User Services may be distributed over p-t-p links if decided to be more efficient

MBMS

Introduced for WCDMA (UMTS) in Release 6
Supports multicast/broadcast services in a cellular system
Same content is transmitted to multiple users located in a specific area (MBMS service area) in a unidirectional fashion
The Broadcast Multicast Service Center (BM-SC) node is responsible for authorization and authentication of content provider, charging, and overall data flow through Core Network (CN)
In case of multicast, a request to join the session has to be sent to become member of the corresponding MBMS service group
In contrast to previous releases of Universal Terrestrial Radio Access Network (UTRAN), in MBMS a data stream intended for multiple users is not split until necessary (in UTRAN, one stream per user existed both within CN and RAN)
MBMS services are power limited and maximize the diversity without relying on feedback from users
Two techniques are used to provide diversity:
- Macro-diversity: combining transmission from multiple cells
  - Soft combining: combines the soft bits received from the different radio links prior to (Turbo) coding
  - Selection combining: decoding the signal received from each cell individually, and for each TTI selects one (if any) of the correctly decoded data blocks for further processing by higher layers
- Time-diversity: against fast fading through a long Transmission Time Interval (TTI) and application-level coding
  - because broadcast cannot rely on feedback (feedback links are not available for p-t-m bearers on the radio access network), MBMS uses application-level forward error-correcting coding, namely Systematic Raptor codes
Streaming data are encapsulated in RTP and transported using the FLUTE protocol when delivering over MBMS bearers
MAC layer maps and multiplexes the RLC-PDUs to the transport channel and selects the transport format depending on the instantaneous source rate
MBMS uses the Multimedia Traffic Channel (MTCH), which enables p-t-m distribution. This channel is mapped to the Forward Access Channel (FACH), which is finally mapped to the Secondary-Common Control Physical Channel (S-CCPCH)
The TTI is transport channel specific and can be selected from the set {10 ms, 20 ms, 40 ms, 80 ms} for MBMS